Search the Community
Showing results for tags 'rubber'.
Found 2 results
1.rubber hardness Test method of indentation hardness based on GBT531.1-2008 rubber pocket hardness tester contents and requirements Instruments and equipment: Shahr hardness tester (type A, D) Environmental conditions: the laboratory temperature is 23 C + + 2 C, the relative humidity is 60%~70231 Test method: the specimen thickness is at least 6mm. If the thickness of the sample is less than 6 mm, it can be stacked with no more than 3 layers of smooth, parallel samples with each layer thickness not less than 2 mm. The specimen must have enough area to make the needle and specimen contact position at least 12mm from the edge. Place the specimen on a solid plane, hold the hardness tester, press the pin at least mm from the edge of the specimen, press the pin smoothly on the specimen, and read it within 3 seconds after the full contact of the pin with the specimen. Results: the hardness values were measured 5 times at different locations of 6mm, and the median was taken. Feilong Jiangli will update the more inspection rules for automobile rubber parts
There is a product out on the market that is perfect for car hobbyists/enthusiasts called Versimold. It is a ready to use silicone that can be molded into gaskets, bumpers, o-rings etc. perfect for antique cars where availability of these parts are scarce. It molds then cures by applying a heat gun, turns into a durable rubber part. We also are the manufacturers of ER tape, a silicone rubber self-fusing tape that is superior to other brands in the market. Both were just featured on Stacey David's Gearz show. Visit us on our website and take a look - www.Rowe-Performance.com Feel free to email with any questions on the Rowe-Performance website.