Jump to content
Sign in to follow this  

Launch X431 PAD V Solved Honda Civic Fault B2A60-54 Static Camera Aiming Incomplete

1 post in this topic

Recommended Posts

After replacing the front windshield for the Honda Civic, you may find a fault called B2A60-54 Static Camera Aiming Incomplete. Use Launch X431 PAD 5 and X431 ADAS PRO can easily solve this problem.


Vehicle and devices used:

Car model: Honda Civic Type R (2017)

Launch X431 PAD V (X431 PAD 5)

Launch X431 ADAS PRO



Case: Start the car, and the warning lights appear on the dashboard.



Guide to solve B2A60-54 Static Camera Aiming Incomplete fault:

Make sure the connection between launch devices and vehicle is proper

Start to operate on X431 PAD V tablet

1.Perform full diagnosis

Select Local Diagnose-> Asian-> HONDA-> 16 PIN DLC-> General

(Connect the VCI in WiFi mode)

Read out the vehicle info


Go to System and Function-> System Topology

The B2A60- 54 fault code can be found in the System List


Select ADAS Calibration-> ADAS System Scan

Click Start scanning


You can see there is a DTC (B2A60- 54) appears on LDW/ACC Integrated Driver Support system (IDAS)



Record or print the ECU ID info readout


2.Read fault code

Select Read Fault Code-> Confirm the module info incl. VIN, ECU name/identifier/ SN-> Read out fault code



3.Calibrate IDAS

Select “Special Function

When executing the following functions, PHEV, FHEV and RLX Hybrid vehicles must be put into maintenance mode for the engine to run. Refer to the service manual for detailed instructions.

Select Static Camera Aiming and select the ADAS Calibration equipment (ADAS Pro)


Read the on-screen instructions of calibration required and pre-calibration preparation

Setup the ADAS Pro with the distance

Start the calibration and wait for the static camera aiming is complete


Turn the ignition switch off and then turn it on

Confirm to save the ADAS report- The calibration result shows success

After that, read the fault code again

Now there is no trouble code in the Integrated Driver Support System (IDAS), the fault B2A60-54 Static Camera Aiming Incomplete is cleared successfully.

Finally, full diagnose to check all systems working normally, and all warnings are also gone.


Launch X431 PAD V with Smartbox 3.0 Diagnostic Coding and Programming Tool (One Year Free Update) is available in eobdtool.co.uk.


Share this post

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  
- Back to Top -

  • Create New...