Jump to content
Koast

Can Cheap Fuel Injectors Damage My Engine?

3 posts in this topic

Recommended Posts

I need to replace my fuel injectors, but I don’t have the money to spend like 60$ for each (4).

Much cheaper options are on places like Ebay and Amazon (as low as $30-40 for all four), but are they worth it? And if they end up being faulty, am I risking damage to my vehicle?

Share this post


Link to post
Share on other sites

Fuel injectors are used for injecting fuel into the combustion chamber. Its purpose is to atomize the fuel for easy combustion. Purchasing fuel injectors online is good as it saves you some expenses but you need to purchase to a reliable shop or you can check the product if it has a good review and feedback. However, I still suggest consulting your trusted car shop regarding this matter as they might give you a better option. Doing this will prevent any problems as to which purchasing bad fuel injectors can lessen the functionality of your car on the road. Also, there is a possibility of damaging other parts which can cost you more expense and worst it can also risk your safety. Hope this helps!

Share this post


Link to post
Share on other sites

Cheap Fuel Injector Problems

  • Starting issues.
  • Poor idle.
  • Failed emissions.
  • Poor Performance.
  • The engine does not reach full RPM.
  • Increased fuel consumption.
  • Rough engine performance.
  • Surging and bucking under various throttle loads.

Steps To Replace Fuel Injectors
1. The metal rod over the fuel injectors is the fuel rail. Use the socket and ratchet to remove the bolts and brackets holding the fuel rail in place. Depending on the model, some engines will need the fuel line disconnected from the fuel rail in order to move the rail.
2. Make sure the engine is cold enough to touch. Disconnect the battery.
3. Remove plastic engine covers using appropriate socket. Set covers aside.
4. Use pliers to disconnect the electrical connector on each injector.
5. Lift the fuel rail off of the intake manifold, bringing the injectors with it. This takes a good amount of force, as the injectors are attached to the rail, and the sprayer tips are a snug fit in the intake manifold. Don't use so much force, though, that you deform or bend the fuel rail. Pulling straight up (as the injector is oriented) makes for easier removal.
6. Examine the injector. If you see a small metal clip that looks like a staple, use a small flathead screwdriver to remove or depress the clip. Then, while wearing gloves, grasp the injector and work back and forth while pulling to remove from the fuel rail. The injector and rail will drip, so have shop towels ready.
7. Press the injector into the rail until it stops. Attach the metal clip, if equipped.
8. Reattach the fuel rail. This can be tricky, but line up all the injectors over their respective holes, then press each injector until they slide into place.
9. Bolt down fuel rail. Reattach fuel line. Plug-in fuel injector electrical connections.
10. Reconnect battery.
11. Turn the key to the on position and wait 10 seconds before turning to engine start. This will allow the fuel pump to refill the lines and fuel rails before the engine cranks.
12. After the engine drops to the normal idle RPM, turn the engine off. Take a flashlight and check all the injectors for fuel leaks.

Tips
Before installing the new fuel injectors, dip the fuel injector tip (sprayer end) into a small amount of engine oil. This will wet the seals, preventing leaks. If your new injectors came without seals, purchase new injector seals separately rather than reusing the old ones.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
- Back to Top -

×
×
  • Create New...