Jump to content
Sign in to follow this  
Abby Yuan

Inspection rules for rubber parts for automobiles-feilong jiangli supplier

1 post in this topic

Recommended Posts

1.rubber hardness

Test method of indentation hardness based on GBT531.1-2008 rubber pocket hardness tester

contents and requirements

Instruments and equipment: Shahr hardness tester (type A, D)

Environmental conditions: the laboratory temperature is 23 C + + 2 C, the relative humidity is 60%~70231

Test method: the specimen thickness is at least 6mm. If the thickness of the sample is less than 6 mm, it can be stacked with no more than 3 layers of smooth, parallel samples with each layer thickness not less than 2 mm. The specimen must have enough area to make the needle and specimen contact position at least 12mm from the edge.

Place the specimen on a solid plane, hold the hardness tester, press the pin at least mm from the edge of the specimen, press the pin smoothly on the specimen, and read it within 3 seconds after the full contact of the pin with the specimen.

Results: the hardness values were measured 5 times at different locations of 6mm, and the median was taken.

Feilong Jiangli will update the more inspection rules for automobile rubber parts

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  
- Back to Top -

×
×
  • Create New...